ANPING SANXING WIRE MESH FACTORY ensures that you'll get the best return by our cooperation with:
*Excellent Quality
*Competitive Price
*Content Service
*Delivery On Time
*Free Sample for Trial
Product introdution:
Perforated metal panels and screens for architecture can be used as balcony, partitions, faç Ade, elevator cabinet and other parts of buildings.
Materials: Stainless steel sheets, aluminum or galvanized iron sheets.
Specify the following when order:
Materials;
Hole pattern;
Open area;
Strength;
Hole size and thickness. Typical patterns for perforated screen include slotted, embossed, diamond, square and round. Slotted perforated metal is produced in ferrous materials in plates, stainless steel or galvanized steel.
Oblong Slotted Perforated Metal Screen Information:
3.175 x 25.400 mm oblong slot
6.350 mm centers
Side Staggered
43% open
22 gauge steel
Length of oblong slots run length of sheet.
1/4" Slotted Perforated Metal Screen
6.350 x 38.100 mm slot
Every third bridge 4.763 mm wide
Other bridges 2.381 mm
67% open area of sheets
16, 18, 20 gauge steel
Length of slots runs width of perforated sheet.
Mesh sizes and plate thickness typical available:
DE 1.2X5 D/C 7 X 7.5mm
DE 2X14 D/C 14X21mm
DE 2.5x20 D/C14X25mm
To:
DE 5X20X D/C 16X44mm
DE 8X20 D/C 25X46mm
Other specifications are at the buyer's option
Sealand is a trustworthy manufacturer of Gas Mass Flow Meter, Gas Mass Flowmeter, Gas Flow Meter, Gas Flowmeter, Gas Meter, ATEX, IECEx & CE approved.
The installation is as follows.
1. Installation Steps
a) Choose correct installation site, taking installation area, pipeline, transmitter location &
valve location into consideration;
b) Install the meter according to direction mark on sensor;
c) Install the sensor & transmitter on pipeline;
d) Connect transmitter & sensor with 9-pin cable;
e) Start.
a) Sensor stays away from mechanical vibration source, for example, pump. Use flexible pipe to connect meter with pipeline if inevitable. The housing of meter must be standalone, out of touch with any other device. There must be 3 times the size of sensor between 2 sensors if there are many flow meters on the same pipeline, to avoid resonance.
b) Do not install sensor on pipeline that easily expands with hot and contracts with cold, especially near expansion joint, which leads to a worse stability.
c) Sensor stays away from industrial electromagnetic field, such as large generator and transformer, better 5m at least. Such device influences the performance of drive coil and pickoffs. Make sure magnetic field intensity less than 400A/m.
d) Sensor shall be installed on lower pipeline, to be easily full of fluid.
e) Make sure Ex-mark meet application requirements if in hazardous area.
f) Build a sunshade if the meter is under direct solar radiation. g) Keep the meter from corrosive liquid.
Gas Mass Flow Meter, Gas Mass Flowmeter, Gas Flow Meter, Gas Flowmeter, Gas Meter
Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeter.com