When people are decorating their homes, they will inevitably have to punch holes in the walls. However, some people do not know much about wall punching. Unscrupulous fights not only affect beauty, but also cause some safety problems. What are the methods of wall punching? What are the precautions for wall punching? The following Xiao Bian will share with you on these issues and look forward to helping those in need.
What are the methods of wall punching?
In order to ensure the safety of the construction, it is not recommended that the owner personally hands it over. The wall punching is usually done by a professional master. Inadequate professional technicians may not only damage the wall, but may also cause accidents and threaten the interests of the owners. When calculating the drilling fee, it is also necessary to communicate with the construction party on various details and strengthen supervision so as not to be regretted.
What are the two methods of wall punching?
Corresponding punching tools should be prepared before construction. In general, the masters will bring their own. Everybody should choose the corresponding punching tool according to the material of the wall. If it is red brick wall, you can directly use the cement nail to screw in. If it is the concrete wall, you must first use the electric hammer to punch and then use the wooden wedge. Knock into the hole and then nail the wooden bar, then the shelf is fixed on the wooden sticky note, and then do not use other wood with wooden sticky note flat and then nailed veneer panel paint.
What are the notes on wall punching?
Drilling is very simple, but it is actually a technical job. Don't worry about it when people are punching. In the process of punching, it should be pulled back and forth so as to prevent sticking of dry powder. In addition, the drill bit must be stable when the wall is punched. Do not shake it left or right. Because you shake it, it is equivalent to increasing the friction of the drill.
Wall drilling precautions which two
Some people have an impatient affair and they always like to get things done in one step, but they can't do it when they punch. Everyone should take good care of the pressure. When they are difficult to hit or when they are slow to fall, they must pull out the drill bit to see if there is a broken brick inside the drill bit. In addition, in the absence of water pipes or water sources, it is best not to drill holes by adding water to the drill bit. Because only a small amount of water is needed, the water will stick the powder and make up the mud. Increase the friction of the drill bit, then it is harder than dry or water.
The above is the Xiaobian on the wall hole method and what are the wall hole drilling matters related to what is relevant to share, for everyone to make a reference! If you have more related issues, welcome to continue to pay attention to the Qi family information, later will Give more exciting content for everyone.
Macor Ceramic Structural Parts
Low-expansion and zero-expansion glass-ceramics are insensitive to temperature changes and can be used in applications where temperature changes but dimensional stability is required, such as housings for telescopes and lasers. The low expansion lithium-based glass ceramic is used for the fiber joint, and is more compatible with the Quartz Glass fiber in terms of thermal expansion coefficient and hardness than the zirconia material, and is easy to be precision processed and has good environmental stability.
Machinable Glass Ceramic Structure Parts,Machinable Ceramic Insulator,Industrial Ceramic,Machinable Glass Ceramic Rod
Dongguan Haikun New Material Co., Ltd. , https://www.nitrideceramic.com