Application of CimatronE 5-axis interference inspection in impeller machining (3)

The generated tool path is as follows:

This toolpath does avoid the tool's interference with the drive surface and the inspection surface, but the knife is axially down, which is obviously not the tool path we want.

3, parameter settings

Enter the advanced parameter page of the interference check, as shown below. We see that the minimum and maximum default values ​​for the tilt angle are 0 and 180.

The value here is relative to the Z axis. As shown below:

Set the maximum value to 45. Check "Keep original tool axis direction" and set "Initial direction limit" to 20.

As shown in the figure below, the tool axis tilt range is now within the yellow outline.

Application of CimatronE 5-axis interference inspection in impeller machining

Generate the following path. Got the knife we ​​want.

Application of CimatronE 5-axis interference inspection in impeller machining

Previous page 1 2 3 Next page

Commercial Retractable Gate Opener

Auto Gate Sliding Opener,Liftmaster Sliding Gate Opener,Commercial Sliding Gate Opener,Commercial Retractable Gate Opener

GUANGDONG BEIDI SMART SCIENCE & TECHNOLOGY CO LTD , https://www.beidimotor.com