Paving the floor is a major event in the renovation. Generally, the floor of the TX floor is finished, and the decoration is almost completed. I am a bit special because I let the migrant workers hit the skirting board, and there are some problems in the engineering connection. I dry it after I finish the floor. For two weeks, every day, fearing to break the floor, I was afraid. I was able to break it at last. I broke a small piece for no apparent reason.
〗 〖Experience
Because I did not like the skirting board that was built on the JS floor and allowed the migrants to kick the floor, so it was inconvenient to install the floor. I decided to install it first and then put it on the kick, but due to delays in the supply of cabinets and stair treads, the floor was installed. There is still a lot of work left. Before the floor was floored, Ruijia sent people to look at the scene and measured about 98 square meters of the floor. It was basically possible to use the floor, not all leveling, and the local plaster could be used to find it. But when the workers who laid the floor came, they said that the ground is still not enough, and the living room and the upstairs court should all be leveled. The migrant workers in my family quit and asked them if we did what you asked. Why not? The two parties had a dispute and there was no way. If there were two construction teams, the conflict would be difficult to avoid. The workers who laid the floor said it was reasonable, but when I was alive, there were no migrant workers talking about the leveling of the ground. Because they touched them well, the migrant workers did not ask me to add money, nor could I blame the migrant workers in my family. Dilemma is happening. Power outages have saved me. Workers laying the floor will be able to deal with the party. I discussed with Lao Du, and according to Rui Jia's method, I used plastic plaster 108 glue to find all the living rooms and courtrooms upstairs. I made up for the rest in other places, and it dried out in two or three days.
<<< Links: How to Lay Kitchen and Bathroom Tiles
On the fourth day, the workers who laid the floor came again and said that the ground was good. However, the old contradiction was resolved and new contradictions occurred again. I originally arranged the floors that were laid out in the morning downstairs. The workers in my family worked upstairs and went upside down in the afternoon. However, the workers who laid the floor did not do anything. They had to go upstairs and downstairs. The workers in my family did not make concessions. They took great pains to re-arrange their order of work. It was difficult. At noon, I bought a steamed bun, asked the two workers to have a meal together, and let them also have a communication, so there is always a contradiction. Eating, Ruijia's manager Huang came. When I saw her, the workers who laid the floor were nervous. It was estimated that eating at the customer's house violated the company's regulations. I quickly said good things to them. Fortunately, Manager Huang was not to check their work, and I did not say anything in front of me. In the afternoon, I saw the relationship between the two parties’ workers eased. The company’s boss also personally came. It was estimated that there was no problem. They relaxed their supervision and went shopping. However, this left a hidden danger. When I came back, the workers on the floor said that there might not be enough boards. This time I was nervous. I bought stocks. In total, 104 square meters were brought to them. If they were not enough, there was no place to go! I quickly asked the worker to stop and count the board first. If it is not enough, lay down the floor first. The result of the calculation is exactly, one piece is not bad, thank God! But in the end, I found a positive difference. Strictly speaking, it was a small piece that was 15 centimeters long. Let it be spelled out with a tailored board. In a corner of the attic, it is not obvious. To say that these two workers' skills are still good, work is also very agile, the floor finished the effect is very good, but it does not work brains. There was such a trivial matter that the worker asked me to buy 5 cans of glass glue, sticky buckles, and told me to be neutral. I bought 5 barrels of neutral for them and bought 3 barrels of acid for preparing sanitary ware and countertops. But when I came back to see it, the acidity made them use it and gave me four barrels of neutral. I am illiterate?
I had been very happy for the first few days after I had finished laying the floor. Rui Jia's imported floor was really good. Two years ago, except for the bumps at the corners, there was no problem at all and there was no taste. I compared the powder sawn from the floor of my family and neighbors. There are many obvious woody ingredients in my home. The time of sawing is not very high. The neighbor's home is obviously full of glue. When sawing, the green end is flying around. I This is definitely environmental protection. This price can buy such a good board, can it be unhappy? But after two days I discovered that there was a problem that the glue at the floor seams was not wiped clean, mainly downstairs, and there was no problem upstairs. My migrant worker revealed that he had been rubbing the edge of the pavement. In the afternoon when I walked away, I finished cleaning the room and rubbed it again. At this time, some of the glue was dry and it was not clean. This was what I relaxed and left behind. The hidden danger. When I tried it, it was not difficult to get it right, so I decided to wait until it was finished. I made another mistake. 3D glue was not difficult to wipe when it started. When it dried completely, it became very strong. It was strenuous with thin materials. One thing that I must do every time I go to a new house is to lie down on the ground and wipe away glue. I can wipe a few square meters at a time. Whenever I am tired and lying on the ground, I will hate the worker who laid the floor downstairs. I also forgot what his surname is. When the other workers gave my family a living job, I remembered everything except him. However, after standing up, I also feel that I can understand that most people nowadays do not use glue to make laminate flooring, use plastic to make trouble, and the boss does not give extra money. My family’s lives are numerous. At the end of the day, I did not stare at this problem. It is also natural.
〖Experts〗
1, laying composite flooring on the ground have certain requirements, do not strictly require the ground to maintain the level, as long as the distance within two meters, the height difference is not more than 3 mm on it. A simple test method is to stand up the board and see no obvious gap with the ground. Special attention should be paid to the corners of the corner, where the most unevenness is often found.
2, ground leveling methods are many, with the most level of self-leveling cement, with multi-layered or bedding treasure can not only leveling but also improve the sense of foot (the original ground can not be too uneven), but these three methods are relatively high cost, One square meter is estimated to be 20 yuan. The common method is to use a cement mortar for leveling. The disadvantage is that it takes more than two weeks for the cement to dry and there is still a long period of time that cannot be performed. Another method is to use plaster 108 glue, this method is said to be used only in part of the leveling, but my family's entire living room 40 square meters, is dry, there is no problem. Note that a little more than 108 plastic bottles, the plaster and some thin, or gypsum will dry quickly, a large area is not smooth.
3, if it is winter heating when the shop floor should be boarded a few days in advance to the scene, so that the board first to adapt to the house's temperature and humidity, other times the best, but quit is basically no problem. Before cleaning the floor, you must clean the house, otherwise you will run dust from under the kick.
4. The use of glue on the floor is a subject of great debate. My conclusion is that it is best to use it. The reason is: I have looked at many large manufacturers' websites. They all say that even the locks are recommended to use glue. The results I discussed with JS and workers are also good for glue, insurance, but not glue installation and maintenance. I think the lock can only ensure tight connection between the floors, but it can't be without gaps. Water and tiny dust can still penetrate into it. With glue, it can completely close the gap. For a long time use, it must be glue. The problem now is that some JS treat glue-free as a selling point, as if someone is using glue, whose quality is not good and who is not environmentally friendly. The use of glue is bothersome, so most JS do not recommend using glue. In fact, there is no necessary connection between the quality of glue and the floor. There must be some pollution with glue, but the pollution of 3D glue is not serious. Sometimes we only Can choose between durability and environmental protection.
5, shop floor to be along the direction of the main room light source shop, some TX proposed horizontal shop can, of course, there is nothing wrong with, but the long side of the light source, the seam will be more obvious, while not at the entrance Good deal. The single-leaf imitation wood-grain laminate flooring is mostly chromatically-colored. This is deliberately done during production. It is not a matter of quality. It looks really good-looking. Do not force workers to pick the same board when paving.
6, to lay four centimeters on the four sides of the floor to leave enough expansion joints, not to superfluous, fill in the expansion joints; also supervise the workers to cut the floor mats to ensure that moisture can be discharged from the expansion joints, especially ground heating Case. When the composite flooring is over 8 meters in length, it must be cut open. With the buckles, the hot and cold shrinking is a natural law, and no one can violate it. 8 meters, the general room living room + suspension length is also similar, plus the balcony may exceed, if the room does not look good with the buckle, the balcony will not paved the floor, the balcony is full of light, the floor is also easy to fade.
7, the loss rate of composite flooring is also not very good calculations, because the use of locks, cut and not all can be used. In general, the loss is about 5%, which is about 7%. Loss and many factors are related: small room costs, large room province, generally a room should have a loss of about a square meter; wide board generally large loss, narrow plate is relatively provincial; the width of the room has a great impact on the loss, which is mainly With luck, my two rooms downstairs, only took a small piece of about 5 centimeters, but also consumed a whole board, and spent two square meters. Dongtian TX has a method. I repeat, "Two width-sized houses, starting from different directions, and finally switching between the boards that were cut." Of course, the loss is more related to the worker's tactics. It should be said that it is more costly. If there are more, workers should have problems.
8, the role of laying floorboards, like I said that the role of paving tiles is the finishing touch. There are three kinds of kicks, one is the ordinary kick of PVC; the second is the polymer kick is the so-called sunshine kick or emerald kick; the third is to let the migrants hit themselves, with 9 PCT board or 12 PCT board lining, Stick the decorative panel above and close it with the bullet line. Among the three options, PVC kicks are the cheapest, but generally the quality is not good, and the kicking feet collide with more, and it is also more tidal. PVC is easy to crack or the skin is not strong. Polymeric kicking is strong, but there is a problem, that is, it is difficult to deal with Yang angle, and often loose, very ugly. The peasant laborers themselves are more strong in playing kicks and kicks, but they can also keep the door and wait for the wood to be consistent. They look good, but the cost is higher. I spent seven or eight hundred yuan. There are two views of the color of the baseboard, one is consistent with the floor, and the second is consistent with the door, I think the door looks good.
9, with plastic installed, you can also immediately on the person, but within 24 hours to minimize walking, do not move heavy objects within 48 hours, but also to open the window ventilation, promote 3D glue thoroughly dry. The use of plastic installation requires that the amount of glue be sufficient, and should not overflow the interface. The glue that overflowed should be wiped clean in time. It was not a problem when it was not cleaned. It was easy to shovel it with a flat shovel in two or three days, but it was not easy to get it after a long time.
Experience Flooring Flooring Room Cement Concrete Flooring Renovation House Renovation House Renovation Living Room Glass Brick Kitchen Door Kitchen Cabinet Door Floor Tile Glass Door Kitchen Glass Sliding Door Bathroom Tile Color Bathroom Tiles Bathroom Tiles Bathroom Doors Tiles Floor Tiles Balcony Tiles Tiles Kitchen Tiles
Spool Of Christmas Lights,Spool Of Led Lights,Led Spool,Spool Of Led Christmas Lights
DONGGUAN JIANXING LIGHTING ELECTRIC APPLIANCES CO., LTD , https://www.rslightstring.com