Tiles in our lives, the use of space is wide, the style is also varied. Many consumers will use the tiles on the wall, paving to decorate the entire wall, what is the paste on the full-tile wall ? Today we pass the following full-tile wall with what paste content, let's take a look!
Fully tiled wall with what paste
Method 1. The paste on the wall and cement mortar of the floor tile is not good and easy to drop. Therefore, the shop is now paving, often using special tile glue to paste, tile adhesive products, based on the traditional cement products, to improve, add new polymer materials. To make the glue more stable and attached, the construction effect is much higher than the cement mortar paste, but the indoor construction temperature must be maintained above five degrees.
Method 2. If you need to decorate the wall, grind a groove in the back of the tile, insert the copper wire, and fix it with glue. Then fix the keel and glue used for the paving. In the approximate position of the background wall, get the keel, and then use the multi-layer board cover on it. Above the back of the tile that needs to be on the wall, hang it with copper wire to determine the approximate location of the tile. Fix the copper wire embedded in the tile with the screw and use glue to put the tile on the wall.
Method 3. The proportion of cement and mortar to a certain ratio, before laying on the wall, the need to wet the back of the tile with water, tile surface to keep dry. On the back of the tile, smear 20mm mud evenly, put it on the wall, and then tap it with a rubber mallet to keep the wall flat and avoid emptying the floor tile. However, due to the limited adhesion of cement mortar, this type of pavement method is generally not recommended.
Full tile on wall considerations
1. Regardless of the method of sticking on the wall of the floor tile, in order to avoid rework or empty drums, drop phenomenon, we need to brush the adhesive on the back of the floor tile.
2. Before the tiles are placed on the wall, the product needs to be soaked in clean water for about two hours. Because the water absorption of the tiles is not high, the water is soaked in order to increase the adhesion of the tile and the adhesive. If no water is soaked, the construction effect of the tiles may be affected.
3. When we buy tiles, it is not difficult to find the back of the tiles and feel a layer of gray, so we need to clean them before laying so that the tiles can be kept clean. At the same time, we need to put on the wall, and the grassroots also needs to be thoroughly cleaned to clean the wall of dust and impurities.
As for what to paste on a full-tile wall , I will briefly introduce it here and I hope to help you. If you still need more information on the decoration of the tiles, or need to understand other decoration knowledge, here you can pay attention to our site, more exciting news articles, waiting for you.
Tile tile paving full tile on wall with what paste
Spring Tension Set,Circular Knitting Machine Spring,Yarn Spring Tension Set,Spring Textile Tension Set
Changzhou Longfu Knitting Co., Ltd. , https://www.circularmachine.com