German machinery manufacturing production is expected to increase in 2011

Linda, chairman of the German Machinery and Equipment Manufacturers Association (VDMA), announced at the Hannover Industrial Exhibition that the industry's output growth rate will be raised from 10% to 14% this year. The main reason for the increase was: on the one hand, the Federal Statistical Office revised the production index for 2010 upwards; on the other hand, the industry's production level at the beginning of 2011 was better than expected. In January 2011, the industry's output value increased by 23.6% year-on-year, and orders in February increased by 38% year-on-year, of which domestic orders increased by 40%, exceeding the 37% increase in foreign orders.

In 2010, German machinery and equipment manufacturing exports amounted to 125 billion euros, an increase of 11.5%. Among them, exports to China increased by 34.7%, accounting for about one-eighth of total exports, and exports to Turkey and Brazil increased by 32.7% and 30% respectively.

At the same time, neighboring countries in Germany have also benefited from their economic growth. In 2010, German machinery manufacturing imports totaled 45.9 billion euros, an increase of 17.5% year-on-year, and continued to maintain its position as the largest importer of machinery and equipment in Europe. Of the German imports of machinery and equipment, 59.6% of imports (27.4 billion euros) came from the European Union, of which imports from Italy were 4.5 billion euros, ranking first in the EU; imports from Asia were about 8 billion euros, up 33.7% year-on-year. Imports from China reached 2.9 billion euros, an increase of 33.1%; imports from the United States amounted to 3.9 billion euros, an increase of 28.5%.
 

Hot Pipette Tips

The commonly used Pipette kits are mainly composed of a pipette and a pipette tip. The pipette tip is a single empty
Cavity reservoir; the pipette uses the principle of air displacement and controls the maximum displacement of the piston by rotating a screw with an ultra-fine thread
displacement, and then control the amount of liquid suction. There are the following problems when using the above kit for suction: 1. The suction volume is controlled by the pipette
After the pipette is sterilized or used for a period of time, it is easy to cause "hidden" failures, which cause the operator to be difficult to detect.
The actual suction volume is inaccurate, and it needs to be adjusted frequently, and the operation is cumbersome and time-consuming; 2. To improve the pipetting accuracy, the operator's
The operation requirements are high, and it is easily affected by factors such as the suction speed, the depth of the tip below the liquid level, and the inclination angle of the pipette.
The actual suction volume will be heard; 3. The actual suction volume will be affected because the suction head cover is not tight and leaking, and it will not be easily detected; 4.
When performing experiments that require high accuracy, such as analysis, in the operation of equal volume aspiration of liquids with different densities, the actual
The actual suction volume will be affected by the density itself; 5. In order to improve the accuracy, this type of pipette needs to carry out high
Cost-optimized design results in extremely high pipette costs.

1000 ul pipette tips,200ul pipette tips,10ul pipette tips,low retention pipette tips

Yong Yue Medical Technology(Kunshan) Co.,Ltd , https://www.yongyueplat.com