The correct operation of the ring gear pump not only can improve work efficiency, but also to ensure the service life of the pump, and now Xiaobian to say that the internal gear cycloidal pump in the operation of the use of things to note. Internal meshing cycloid gear pump Internal meshing cycloidal gear pump operation and use of precautions (1) If you find that the internal gear cycloidal gear pump should stop immediately abnormal sound Check the reasons (2) to the internal gear cycloidal bearing pump bearing lubrication Oil, observe the oil level should be in the oil center line, the lubricating oil should be promptly replaced or supplemented. (3) Unscrew the internal gear cycloid pump body of the water diversion plug, water diversion (or cited pulp.) (4) Close the internal gear of the cycloidal gear pump outlet valve and outlet pressure gauge and the import vacuum gauge. (5) jog the internal gear motor, try to see if the motor is turning. (6) start the internal gear Pump motor, open the outlet pressure gauge and import vacuum pump, as it shows the appropriate pressure, gradually open the gate valve, while checking the motor load condition. (7) Internal gear cycloidal long-term To be deactivated, the internal gear of the cycloidal gear should be disassembled, dried, and the rotating parts and joints should be coated with grease and properly stored. (8) During the operation of the internal gear with cycloidal gear, the bearing temperature Can not exceed the ring Temperature 35C, the maximum temperature of not more than 80 C. (9) Check the internal gear and the cycloid gearing pump and loose joints with the phenomenon of hand rotating internal gear cycloidal gear pump, see the internal gear cycloidal cycloid is flexible. (10) When the internal gear of the cycloidal gear pump is to be stopped, close the gate valve and pressure gauge first and then stop the motor. (11) The internal gear of the cycloidal gear pump will be changed over 100 hours after the first month of operation Every 500 hours, oil change once. (12) Regular adjustment of internal gear cycloidal gear packing gland, packing room to ensure that the normal drip leakage (as a drop of leakage appropriate.) (13) regular inspection of the internal gear Pump shaft sleeve wear, wear and tear should be promptly replaced. Read More: Pumps Valves Pipe Fittings Exhibition Water Expo Xiamen Maritime Exhibition Internet + Forum Yiwu Expo Fair Mold Top Ten Brands 2016 Exhibition Information Industry Internet (Xiamen ) Technology Co., Ltd. author: Asian pumps network editor: Yao Xiaoxia (QQ / micro letter:) http://beng.liuti.cn/ (service hotline:)
Roll Up Door Servo Motor,Automatic Roller Shutter Door Opener,Roller Shutter Door Servo System,Glass Sliding Door Motor
Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.selfrepairinghighspeeddoor.com