Traction wire collector characteristics, and related troubleshooting

We call the trolley line collector, which is a large-angle sliding power receiver with our company's patent. As for the large-angle slide power receiving device, here we need to describe its large-angle sliding power receiving device, which belongs to the technical field of the traveling power transmission device in the trolley wire collector. It should also be noted here that with regard to the slide power receiving device we use, its safety performance is not good, and it is not very convenient to repair it.

Here's a brief introduction to the characteristics of the trolley wire collector:

First of all, our slide wire collector is a brush bushing with a brush bushing at the bottom, and then the brush bushing can be fastened to the copper brush with a set screw. At this time we found the copper brush. There is a cable at the lower part, so the copper brush is fixed on the bracket through the fixed shaft, and then the lower part of the bracket is inserted into the bracket seat, and what we need to do next is to fix the bracket to the bracket seat through the fixing clip. Above, this would allow the pin and the connecting rod pin to fix the connecting rod to the rotating shaft and the bracket seat, respectively.

Immediately afterwards, we will see that the connecting rod is provided with a pull-bolt pin and a tension spring. In this case, the spring card will fix the rotating shaft on the support seat. It is precisely because of this, we will find that because the slide wire collector reduces the failure rate of the slide power receiving device, it will increase its safety and stability accordingly. There is also a case where the copper brush rotates forward and backward at an angle of 90 degrees centered on the axis of rotation. In this case, it is very convenient for maintenance and repair.

In the end, let's talk briefly about what to look out for when troubleshooting a slippery wire collector.

First of all, if we find that the contact of the trolley wire is poorly connected, we must adjust the trolley wire connector in time, and then tighten the bolts of the connecting plate. The latter is a case where the influence is large, and it is also possible to directly replace the slip. Touch the line; there are words when the contactor piece of the collector wears badly, we need to pay attention, quickly change the contact patch.

Resin Diamond Sanding Belt

Flexible Diamond Resin Bonded Industrial Belts,Diamond Resin Soft Sanding Belt,diamond grit sanding belts,diamond abrasive belts,diamond sanding belts,diamond abrasive disc

Hans Super Abrasive Diamond Tool Co.,Ltd , https://www.hansuperabrasive.com