What are the requirements for air compressor oil repair and maintenance?

When cleaning the dust for the heat dissipation, the cooler purge hole cover on the fan bracket should be widened, and the cooler should be purged with the dust blower until the heat dissipation dust is purged. If the heat dissipation field is severe and difficult to purge, the cooler can be removed, the air compressor oil in the cooler is poured out, and the four inlets and outlets are kept secret to defend the dirt, and then the wind blows off the dust on both sides or Wash the water stains in the water with water. Then put it back in place. remember! Do not use a hard object such as an iron brush to scrape off dirt, so as not to damage the radiator.

1. (1) Emission of condensed water: The moisture in the air may be agglomerated in the oil and gas permeation tank. It is in a humid climate. When the exhaust gas temperature is lower than the air pressure dew point or the shutdown is cooled, there will be more condensed water. Precipitate. Excessive water content in the oil will form an emulsification of the greasy oil, which will affect the stagnant insurance operation, resulting in a poorly slippery host; the oil and gas results will deteriorate, and the pressure difference of the oil and gas will become large; causing corrosion of the machine parts. Therefore, the condensate discharge time table should be formulated based on the humidity situation. Condensate discharge mode: should be in a stagnant shutdown, no pressure in the oil and gas tank, adequate cooling, condensed water back and full of swallowing, such as before the start of the morning. 1 Unscrew the front plug of the ball valve at the bottom of the oil and gas tank. 2 Gradually relax the ball valve drain until the oil flows out and close the ball valve. 3 Screw on the front of the ball valve.

(2) Insurance valve: The safety valve has been set before the machine leaves the factory. We do not propose user cheats to solve the safety valve. If it is necessary to solve the problem, it should be carried out under the guidance of the labor insurance department of the Mainland or the maintenance personnel of the company, otherwise it will have all consequences.

Second, cover treatment suggestions: For the average user, we provide some cover suggestions, users can refer to the implementation. 1 Weekly: Review the unit for extra noise and leaks; review the temperature to reveal whether it reveals normal. 2 Monthly: Review whether there is rust in the machine. If there is rust, remove the rust and oil or paint. 3 every three months: wipe the outside of the cooler and the fan cover, the dust at the fan blade; add greasy oil on the motor bearing; review the hose for aging and splitting.

Third, the compressor oil replenishment oil: Under the operating conditions, the oil level of the compressor should be maintained between the lowest and the highest oil level, oil will affect the results, less oil will affect the sluggish and cool performance, in the exchange During the oil cycle, if the oil level is lower than the minimum oil level, the greasy oil should be filled regularly. The method is: 1 stop and other internal pressure release pause, pull down the main power switch. 2 Relax the filling port on the air compressor tank of the air compressor to fill the proper amount of cooling grease. 3 Refer to the regular screening adjustment table for the oil change time after the machine is in normal operation.