3. According to the above ideas, the main surface of the toothbrush is built, then the transition surface is made according to the main surface, the surface is merged, and finally closed into a solid. In this process, the use of styling's hybrid modeling capabilities, surface and physical interaction applications, greatly improve the design efficiency. Figure 34 main body model
4. After the main body of the toothbrush is built, add other red rubber parts. The effect is shown in the figure (in the rendering mode), and the modeling of the whole toothbrush is basically completed. Figure 41 3D model
Previous page next page
Joint Bearing,Rod End Spherical Bearing,All Joint Rotating Bearing,Spherical Joint Bearing
Shanghai Yi Kai Cheng bearing Co., LTD , https://www.ykcbearing.com