Flooring: 1. The floor should be polished smooth, no pits and scratches can appear, and the corners should be ground with a sander; 2. The floor should be at least three times the floor wax; 3. When laying, four sides should be reserved for millimeters, and then use the skirt line. Edge cover; 4, wood floors should use plywood as the bottom, the bottom of the board should be placed with oil-proof paper or plastic film, and the four sides to reserve vacancies.
Tiles: 1, brick surface to be flat, the angle should be accurate, the interface to the line; 2, the tile is soaked in water for half a day before use; 3, the toilet floor should have a suitable slope, not water; 4, after the tile interface to white cement Wipe the white cement with rattan silk, do not leave cement stains on the surface of the brick; 5. After the tiles are covered, use cardboard to cover the brick surface, and walk on the brick surface after at least 1 hour.
Wallpaper: 1. After the wall is painted over with waterproof oil, it is necessary to polish it. Each time it is polished with sandpaper. The gap must be repaired immediately. The concave wall of the convex wall cannot be seen with the naked eye. 2, the wallpaper to meet the mouth to accurately paste clothes, no blistering, according to the provisions of the flowers, with a sharp incision, there must be no paper edge tearing phenomenon.
Paint: 1, the surface color is correct, uniform, smooth and smooth, no teardrops, too thick, through the bottom, blisters and other conditions; 2, the paint boundary is straight and tidy, not out of bounds; 3, the wall of the gray does not see convex concave Bit, flat corner. Board and board, board and wall interface, should be attached to the tape after the ash; 4, latex paint in the distance from the point of view, should not see the scan marks; 5, nails to be accurate and smooth coloring; 6, try not to be wet Weather brush paint.
In addition, the wooden board surface should be smooth and smooth, without planing marks, squeaks and burrs, the pattern is clear, the paint surface color is uniform, the gap is tight, the joints are staggered, the surface is clean, and the joints are straight and straight. In terms of bonding, it should be firmly bonded, the surface should be clean, there should be no overflowing glue, and the floorboards should be arranged reasonably and beautifully. The joints are tight, the surface is smooth, the seams are arranged in a reasonable and beautiful manner, the mouth is straight, and the cutting angle is accurate. Wooden floor hot hard wax, wiping soft wax, wax spray have to be uniform without exposed bottom, smooth and bright, consistent color.
DELL floor nature floor paint cement latex paint floor tile tile floor tile kitchen tile
High-performance microcentrifuge tubes, optimized design, and high-performance quality help protect your samples. Microcentrifuge tubes are made of polypropylene (PP) and are highly mechanically stable, ensuring your samples are stored, run and centrifuged worry-free.
Microcentrifuge tubes have a maximum centrifugation tolerance of 25,000 x g and are autoclavable (20 minutes, 121°C). The centrifuge tube adopts a snap-on tube cover design, which can be operated with one hand and has good sealing performance, which can effectively prevent liquid leakage; the tube wall is smooth, and the tube body is designed with a frosted area for convenient marking.
microcentrifuge tube sizes,microcentrifuge tubes 1.5 ml,microcentrifuge tubes uses
Yong Yue Medical Technology(Kunshan) Co.,Ltd , https://www.yongyuemedicals.com